v2.00 1) BFGMiner revision 5.1.0. 2) Fixes to the BFGMiner driver which decrease the number of Rejects. 3) Special voltage fix for some ill-behaving boards. Improves stability and prevents dies from going off. 4) fix: ASIC is not shown on Advanced page when all dies are turned OFF. v1.97 1) Fix bug: sometimes ASICs are detected, but not mining. 2) Show correct average Clock (Status page) in case when some dies are OFF. v1.96 1) Make load more evenly balanced between pools in load-balance mode. 2) Fix incorrectly shown percentage of Rejected/Stale shares. 3) Fix rolling hashrate display in "detail level:processors" view. v1.95 1) New FPGA image with I2C lock-up problem solved. 2) Support for Scrypt-N (not fully optimal yet). 3) Add ability to change miner's name in web interface. v1.94-beta 1) Support for Scrypt-N. Beta version, not all modes are tested well enough. 2) New FPGA image with I2C lock-up problem solved. v1.15 1) BFGMiner update to 5.0.0. 2) Add Shutdown button to System page in web interface. v1.14-1 Minor improvements: 1) Reduce SD card wearout by moving some files from /etc/ to /var/run/ 2) Show current release revision in web interface (System/Firmware Upgrade). 3) Lower log level for some messages to make BFGMiner output a bit cleaner. v1.14 1) BFGMiner driver restructurization to reduce CPU load. Possibly reduces number of rejects. 2) BFGMiner API calls optimization. Possibly helps with frequent BFGMiner restarts. v1.11 1) Bugfix: don't send garbage after SPI commands to FPGA. This fixes "LED shows random colors" problem and possibly some others. 2) Bugfix: don't crash BFGMiner because of SPI communication errors. This possibly fixes frequent BFGMiner restarts. 3) Improvement: Init last_nonce on die config. This possibly fixes "High number of rejects after die reconfig". v1.10 1) Flush time is reduced to 0.5 s, which increases performance. 2) Running average per-ASIC BFGMiner counters show correct values. 3) Configurable number of attempts for io-pwr board initialization. v1.05 1) Submit shares during flash procedure. 2) Upper frequency limit is 325 MHz. 3) Ability to switch off offending dies. v1.04 Two major improvements: 1) bfgminer is not restarted on die failure; instead, die is reconfigured individually. 2) Flush time reduced to 4 secs thanks to batched SPI transfers. v1.03 Short changelog: 1) Improved Advanced page stability. 2) Shut down DC/DCs before reboot/shutdown of RPi, so that would not go into faulty state after reboot. 3) Upgrade BFGminer to 4.8.0. v1.02 Titan 1.02 release fixing I²C issues that caused frequent reboots and performance improvements on block flushes. v1.01 Initial release of Titan miner software.